The following table summarizes the linear system characteristics you can specify bounds on and assert that the bounds are satisfied during simulation.
| Block | Plot Type | Bounds on… |
|---|---|---|
| Check Bode Characteristics | Bode | Upper and lower Bode magnitude |
| Check Gain and Phase Margins |
| Gain and phase margins |
| Check Nichols Characteristics | Nichols |
|
| Check Pole-Zero Characteristics | Pole-Zero | Approximate second-order characteristics, such as settling time, percent overshoot, damping ratio and natural frequency, on the pole locations |
| Check Singular Value Characteristics | Singular Value | Upper and lower singular values |
| Check Linear Step Response Characteristics | Step Response | Step response characteristics |
Specify the bounds in the Bounds tab of the block's Block Parameters dialog box or programmatically. For more information, see the corresponding block reference pages.