To initialize the output values for a conditional subsystem, initialize Outport blocks within the subsystem by using one of these methods:
Inherit initial output values from input signals connected to the Outport blocks.
Specify initial output values using Outport block parameters.
Note
If the conditional subsystem is driving a Merge block in the same model, you do not need to specify an initial condition for the subsystem Outport block.
Simulink® attempts to use input signals connected to conditional subsystem
Outport blocks to initialize output values. This behavior is seen after
setting the Outport block parameter Source of initial output
value to Input signal. The exact same behavior is
seen when Source of initial output value is set to
Dialog and Initial output is set to
[].
Valid input signals for setting initial output values are:
Output ports from another conditionally executed subsystem
Output ports from a Model block with a Trigger block set to function-call
Merge blocks
Constant blocks
IC (initial condition) blocks
Simulink signal object attached to the signal line connected to the
Outport block. If the InitialValue parameter is
defined, Simulink uses this value.
Stateflow® chart
If the input signal is from a block that is not listed here, the Outport block uses the default initial value of the output data type.
Note
If you are using classic initialization mode, selecting Input
signal causes an error. To inherit the initial output value from an input
signal, set the Source of initial output value parameter to
Dialog, set Output when disabled to
held, and set Initial output to the
empty matrix [].
Explicitly set the initial output values in cases where you want to:
Test the behavior of a model with various initial values.
Set initial values to steady state and reduce simulation time.
Eliminate having to trace input signals to determine the initial output values.
To specify initial output values
Open the dialog box for an Outport block within a conditional subsystem.
From the Source of initial output value drop-down list, select
Dialog.
In the Initial output box, enter the initial value.