Insert a table that links MATLAB code to requirements
This component inserts a table into the report. The table links MATLAB® code to corresponding requirements. This component reports on the currently
open .m file. Place this component inside a section, paragraph, or table
component.
To use this component, your report setup must include Eval
statements that open a .m file or determine the .m
file that is open. To open a template report that shows an example of these
Eval statements, at the MATLAB command prompt, enter:
setedit([matlabroot '/toolbox/slrequirements/+rmiml/rmiml.rpt'])Find theEval statements in the if condition at
the beginning of the report setup.
Specify information about the table.
Table title: Specify the table title.
No title — Do not include a table
title.
Object name — Use the name of the
.m file in the title.
Custom — Specify your own table title.
Specify the table columns that you want to include in the report. The Document name, Locations within document, and Requirement keyword check boxes correspond to properties on the Requirements Management Interface Link Editor dialog box.
Description — Include the description of the requirement. The description helps you to identify the requirement the table is linking to. Leave this box selected to improve the readability of your table.
Document name — Include the name of the document where the requirement is located.
Locations within document — Include the identifier of a location in the document.
Requirement keyword — Include the requirement keyword.
Yes. Table.
RptgenRMI.MlReqTable
Data Dictionary Traceability Table,
Simulink Test Suite Traceability Table,
rmi (Simulink Requirements)